Pioneer VSX-D711, VSX-D811S manual Connecting up AC outlet, Operating other Pioneer components

Connecting up 03

AC outlet
[switched 100 W (0.8 A) max]
Power supplied through this outlet is turned on and off by the
receiver's POWER switch. Total electrical power consumption of	AC OUTLET
connected equipment should not exceed 100 W (0.8 A).	SWITCHED
	100 W MAX
	0.8 A MAX
DO NOT CONNECT A MONITOR, TV SET, HEATER, OR SIMILAR
APPLIANCE TO THIS UNIT'S AC OUTLET.
Do not connect appliances with high power consumption to the
AC OUTLET in order to avoid overheating and fire risk. This can
also cause the receiver to malfunction.

•Make sure no exposed speaker wire is touching the rear panel, this may cause the receiver to turn off automatically.

•This unit should be disconnected by removing the power plug from the wall socket when not in regular use (ex. when on vacation).

POWER-CORD CAUTION

Handle the power cord by the plug. Do not pull out the plug by tugging the cord and never touch the power cord when your hands are wet as this could cause a short circuit or an electric shock. Do not place the unit, a piece of furniture, etc., on the power cord, or pinch the cord. Never make a knot in the cord or tie it with other cords. The power cords should be routed such that they are not likely to be stepped on. A damaged power cord can cause a fire or give you an electrical shock. Check the power cord once in a while. When you find it damaged, ask your nearest Pioneer authorized service center or your dealer for a replacement.

Operating other Pioneer components

By connecting a control cord (optional), you can point the remote controls of other Pioneer components at the receiver’s remote sensor. The remote control signals are received by the remote sensor of this unit, and sent to the other devices via the

CONTROL

IN

OUT CONTROL

OUT

CONTROL OUT terminal.

Receiver

Remote control unit

Other Pioneer products with Î mark

Connect to CONTROL IN terminal of other Pioneer products with Î mark.

25

En

XRB3013A.13.25 25 01.12.12, 4:43 PM