FILTER PROCEDURES FOR FLAT PAPER FILTER SYSTEMS
NOTE
When working with hot oil ALWAYS wear oil
proof, insulated gloves.
WARNING
NEVER - Run the filter system without a filter bag/paper.
NEVER - Empty the oil from the fryer before turning OFF the fryer burners.
NEVER - Store the Filter Unit anywhere other than in the fryer filter cavity.
a.Slide the filter pan out. Carefully remove filtered residue off the filter media. Examine the filter media for clogged or torn areas. Refer to filter media replacement instructions following this section. Reinstall the pan.
b.Turn the fryer that is to be filtered OFF (See Standby Shutdown). Remove the baskets from the fryer tank(s). Use the clean out brush to lift out the tube screens.
c.Check the pickup tube screen by unscrewing the cap counterclockwise. Any debris should be cleaned from the screen before using the filter system. Reinstall the screen by scewing the cap back on clockwise. Do not over- tighten.
c.Slowly open the green handled drain valve for the tank being filtered. If necessary use the
WARNING
This filter pan is only large enough to hold the contents of one (1) tank at once, during the filter process.
e.When the tank is empty, close the green handled drain valve. Open the red handled
return valve to the tank you are filtering. This will start the pump and return the oil to the bottom of the fry tank.
f.When bubbles are seen coming out of the oil return spout, close the red handled valve to turn the pump off.
If necessary add more oil to the tank to return the oil level to the fill mark. The fryer is now ready for use.
DRAINING A TANK
The filter system is also used to drain the fryers. You will need a container capable of holding 4000F oil and protective gloves.
a.Rotate the drain down spout so that it ex- tends in the container that you want to drain the shortening into.
b.Open the green handled drain valve for the tank to be drained. The oil will drain into the container you have chosen. When the con- tainer is full or the fry tank is empty, close the green handled drain valve. If the con- tainer was full repeat this step until fryer tank is empty.
c.Once tank is completely empty add new shortenning and follow fryer start up proce- dures.
WARNING
The power supply must be disconnected before
servicing or cleaning the appliance.
Preparing the filter for use:
·Slide drawer forward until it stops.
·Grasp the Left and Right handles of the Paper Retaining Frame and lift upward to remove it.
·Remove the filter paper or pad by folding the edges inward so that the debris is collected.
·Lift the Paper Support Screen out of the pan.
·The Pan, Paper Support Screen and Paper Retain- ing Frame can now be cleaned.
NOTE: Be sure that the filter pan is free of any debris which could cause the paper and hold down ring not to seat properly.
3 |
