Planar PR9020 user manual Network Menu, Setup

NETWORK Menu

NETWORK Menu

Remember that incorrect network settings on this projector may cause trouble on the network. Be sure to consult with your network administrator before connecting to an existing access point on your network.

Select “NETWORK” from the main menu to access the following functions.

Select an item using the ▲/▼ cursor buttons on the projector or remote control, and press the ► cursor button on the projector or remote control, or ENTER button on the remote control to execute the item. Then perform it according to the following table.

See the User’s Manual - Network Guide for details of NETWORK operation.

NOTE • The factory default setting for DHCP is OFF. If your network has DHCP enabled, and needs to set IP ADDRESS, SUBNET MASK and DEFAULT GATEWAY automatically, please set DHCP to ON. ( Network Settings of the User’s Manual - Network Guide)

•If you are not utilizing SNTP ( Date/Time Settings of the User’s Manual - Network Guide), then you must set the DATE AND TIME (57) during the initial installation.

Item		Description
	Selecting this item displays the SETUP menu
	for the network.
	Use the ▲/▼ buttons to select an item, and
	the ► or ENTER button on the remote control
	to perform the item.
SETUP		Use the ▲/▼ buttons to turn DHCP on/off.
		ON  OFF
	DHCP	Select OFF when the network does
	(Dynamic	not have DHCP enabled.
	Host	• When the “DHCP” setting changes to “ON”, it takes a
	Configuration
	Protocol)	little time to obtain IP address from DHCP server.
		• Auto IP function will be assigned an IP address if the
		projector could not obtain an IP address from server
		even if DHCP is “ON”.
(continued on next page)

55