DIP Switch Table

Some models are fitted with DIP switches.

∙The default position for all switches is UP.

∙Normally, there is no need to change the settings of the DIP switches.

∙The purpose of these switches is described in the following tables. Any other pos- sible settings are reserved, and should not be used.

Print Servers (FPS-5P-M, FPS-5P-S)
SW1SW2SW3

Description

 

 

 

 

UP

-

-

Auto select LAN connection (Default)

 

 

 

Switches 2 and 3 have no effect

Down

Down

Down

10Base-T - Half Duplex

 

 

 

 

Down

Down

UP

10Base-T - Full Duplex

Down

UP

Down

100Base-TX - Half Duplex

Down

UP

UP

100Base-TX - Full Duplex

 

 

 

 

Diagnostic Push Button

Print Server FPS-1UA/FPS-2PUW/FPS-2PUWG are fitted with a Diagnostic Push But- ton. The button is recessed; a pin or paper clip can be used to press it. This button has 2 functions:

∙Restore the factory default settings

∙Print a test page containing all current settings.

To restore the factory default settings:

1.Turn the Print Server OFF.

2.Press and hold the diagnostic button. While pressing the button, switch the Print Server ON.

3.If you continue pressing the button for 10 seconds, a diagnostic page will be printed, showing the new (default) settings.

To generate a Diagnostic print out

1.Ensure that both the Print Server and the printer attached to port 1 are ON.

2.Press the diagnostic button, and hold it in for 2 seconds.

3.The test page, containing the current settings, will be printed.

Note:

PostScript printers are unable to print this page. If you have a PostScript printer on Port 1, the test page will not be printed.

Page 10