a sticker on the base of the device.

Reset Device This will cause the device to reboot. This should be done after making any configuration changes, or if the device stops responding after some problems.

Restore Fac- This will restore ALL device values to their factory defaults. To

tory Default restore only the current screen, use the Set to Default button on the screen.

Set IP Address For TCP/IP networks only:

∙If a Print Server does not appear on the main screen, use this option to set a Device IP Address, Gateway IP Address, and Network Mask to the Print Server.

∙This should only be necessary if your LAN is using ONLY the TCP/IP protocol. In other cases, Bi-Admin will use IPX/SPX to locate the Print Server even if it doesn't have a valid IP Address.

∙To locate the Print Server, enter the Default Name. The De- fault Server Name is shown on a sticker on the base of the device.

∙Enter the required IP Address, Network Mask, and Gateway IP Address.

∙After saving the data to the device, refresh the listing. The Print Server should then appear in the device list on the main screen.

Upgrade Upgrade the firmware in a Print Server. See Upgrade Icon for details.

Page 38