Manuals / Brands / Computer Equipment / Network Router / Planet Technology / Computer Equipment / Network Router

Planet Technology GRT-501 2.2 Rear Panel Connections, „Port Definition

1 51

Download 51 pages, 4.2 Mb

GRT-501 G.SHDSL.bis Bridge Router User’s Manual

Port Definition

Port	Description
DC-IN	Power connector with 9V DC 1.0A
LAN	Ethernet 10/100BaseT for LAN port (RJ-45)
CONSOLE	RS- 232C (DB9) for system configuration and maintenance
LINE	G.SHDSL.bis interface for WAN Port
RST	The reset button, the router restore the default settings when press this
	button until reboot.

2.2 Rear Panel Connections

The figure shows the rear panel connections of GRT-501.

The GRT-501 is a standalone and can able to place in desktop. All the external wiring shall be located at the rear panel. The LAN port is a 10 Base-T / 100Base-TX auto-sensing and half/full duplex Ethernet interface and complied with IEEE 802.3 / 802.3u respectively. The console (RS-232C) interface for configuration is menu-driven operation and can also be configured through Ethernet interface by Telnet or Web-based operation.

Figure 2-1 Connection with Switch or HUB

Note: The GRT-501 supports auto MDI / MDI-X switching hub, so both straight through and cross-over Ethernet cable can be used.

- 9 -

Contents

Page Copyright Disclaimer Trademarks CE mark Warning Federal Communication Commission Interference Statement FCC Caution: R&TTE Compliance Statement WEEE Caution Safety Customer Service Table of Contents Page Chapter 1 Overview Product Features Hardware Specification Package Contents 2.1 Get to know your G.SHDSL.bis Router 2.2 Rear Panel Connections 2.3 Setting up the hardware environment 3.1 Serial console 3.2 Telnet 3.3 Web browser Chapter 4 Configuration by Web Browser 4.1 Basic Setting 4.1.1 Bridge Mode Web UI Configuration Page 4.1.2 Routing Mode for PPPoA and PPPoE with IP Sharing Page 4.1.3 Routing Mode for IPoA or EoA Page 4.1.4 LAN-to-LANConnection with Bridge Mode STU-R(CO) side STU-C(CPE) side 4.2 Advanced Setup 4.2.1SHDSL.bis 4.2.2 WAN Page 4.2.3 Bridge 4.2.4 VLAN 4.2.5 ETHERNET 4.2.6 Route Page 4.2.7 NAT/DMZ Page 4.2.8 Virtual Server 4.3 Status 4.4 Administration 4.4.1 Security 4.4.2 SNMP Page 4.4.3 Time Sync Page 4.5 Utility 4.5.2 Config Tool 4.5.3 Upgrade 4.5.4 Logout 4.5.5 Restart Appendix A: VLAN Specification Frame Specification Applications 2.802.1Q VLAN 802.1Q VLAN Example Appendix B: Glossary DHCP (Dynamic Host Configuration Protocol) DMT Downstream rate DSLAM Dynamic IP Addresses HTML HTML browser http ICMP Internet address NAT NVT PAP PORT POTS Router Routing Table Routing Information Protocol SNMP SOCKET Subnet TCP TFTP Transparent bridging UDP Virtual Connection (VC)