Planet Technology GRT-501 2.3 Setting up the hardware environment

GRT-501 G.SHDSL.bis Bridge Router User’s Manual

Step 1. Connect the power adapter to the port labeled DC-IN on the rear panel. Step 2. Connect the Ethernet cable between the LAN port and PC.

Step 3. Connect male end of RS-232 cable to the console port and female end to any free COM port in PC.

Step 4. Connect the phone cable to the Line port, and the other side of phone cable connects to wall jack.

Step 5. Connect the power adapter to power source.

Step 6. Turn on the PC or NB, which is used for configuration the Router.

- 10-

Contents

Page Copyright Disclaimer Trademarks CE mark Warning Federal Communication Commission Interference Statement FCC Caution: R&TTE Compliance Statement WEEE Caution Safety Customer Service Table of Contents Page Chapter 1 Overview Product Features Hardware Specification Package Contents 2.1 Get to know your G.SHDSL.bis Router 2.2 Rear Panel Connections 2.3 Setting up the hardware environment 3.1 Serial console 3.2 Telnet 3.3 Web browser Chapter 4 Configuration by Web Browser 4.1 Basic Setting 4.1.1 Bridge Mode Web UI Configuration Page 4.1.2 Routing Mode for PPPoA and PPPoE with IP Sharing Page 4.1.3 Routing Mode for IPoA or EoA Page 4.1.4 LAN-to-LANConnection with Bridge Mode STU-R(CO) side STU-C(CPE) side 4.2 Advanced Setup 4.2.1SHDSL.bis 4.2.2 WAN Page 4.2.3 Bridge 4.2.4 VLAN 4.2.5 ETHERNET 4.2.6 Route Page 4.2.7 NAT/DMZ Page 4.2.8 Virtual Server 4.3 Status 4.4 Administration 4.4.1 Security 4.4.2 SNMP Page 4.4.3 Time Sync Page 4.5 Utility 4.5.2 Config Tool 4.5.3 Upgrade 4.5.4 Logout 4.5.5 Restart Appendix A: VLAN Specification Frame Specification Applications 2.802.1Q VLAN 802.1Q VLAN Example Appendix B: Glossary DHCP (Dynamic Host Configuration Protocol) DMT Downstream rate DSLAM Dynamic IP Addresses HTML HTML browser http ICMP Internet address NAT NVT PAP PORT POTS Router Routing Table Routing Information Protocol SNMP SOCKET Subnet TCP TFTP Transparent bridging UDP Virtual Connection (VC)