- 93 -
NetMgmt A routing entry set via SNMP.
ICMP A routing entry obtained via ICMP redirect.
RIP A routing entry learned via the RIP protocol.
Other A protocol other than one of the other four listed above.
From the Routing Table screen, you can:
Add entries to the Routing table. See section 5.6.3.1Adding Routing Table Entries”.
Delete entries from the Routing table. See section 5.6.3.2Deleting Routing Table Entries”.
Search for entries in the Routing table. See section 5.6.3.3Searching for Routing Table Entries”.
5.6.3.1 Adding Routing Table Entries
To add entries to the Routing table:
1. From the Routing Table screen, hold down the Shift key and press +. The Route Options screen
appears.
FIGURE 5-54
2. Select Default Gateway or Static Route, then press Enter.
If you selected Default Gateway, the following screen appears. Press Enter and type an IP
address for the default gateway. The address consists of numbers separated by periods. For
example: 129.32.0.11. When you finish, press Enter. Then proceed to step 3.