- 9 -
FIGURE 2-4 FRONT PANEL OF WGSW-404
Console
Status LEDs
10/100/1000 Mbps ports Expansion Ports
Table 2-5 Port Function
TABLE 2-5 PORT FUNCTION
Ports # of Ports Description
Console 1 This is where you can connect to the RS-232 serial port on
your PC for configuring the management function.
10/100/1000 4 These RJ-45 ports support network speeds of 10, 100 or 1000
Mbps, and can operate in full-duplex modes.
Expansion
Ports 4
These ports provide for the installation of one or two
expansion modules that establish a Fast or Gigabit Ethernet
connection.
Note: You may install an 1000Base-SX, 1000Base-T or
100Base-FX expansion module and use fiber optic or
category 5 cabling.
The LEDs indicate the status of 10/100/1000 Mbps Ethernet ports, Over Heat, Fan Failure and Power.
The LEDs are explained in the following tables.
TABLE 2-6 POWER AND STATUS LEDS
LED Color Function
Power Green Lights to indicate that the Switch has power.
Over Heat Red Lights to indicate that the Switch exceeds its operational
temperature.
Fan Failure Red Lights to indicate that the fans are not active.
TABLE 2-7 PORT STATUS LEDS
LED Color Function
Act Green Lights to indicate the Switch is actively receiving or
sending the data over the port.
FDX/COL Yellow
Lights green to indicate that the port is operating in
full-duplex mode.
Blinks orange periodically to indicate that the connection
is experiencing collisions.
1000 Green Lights to indicate that the Switch is sending or receiving
data at 1000 Mbps.
100 Green Lights to indicate that the Switch is sending or receiving
data at 100 Mbps.
10 Yellow Lights to indicate that the Switch is sending or receiving
data at 10 Mbps.