3. Using scrivo.1
scrivo.1 has a power switch, two function buttons, and two indicators.
Power switch
Pairing Button
Second button
First Button
Battery indicator
Correct way to hold scrivo.1
When using a typical ballpoint pen, you can write on a paper regardlessof how you hold the pen. On the other hand, if you hold a fountain pen and rotate its pen tip to an upright posi- tion, you cannot write at all since the tip of a fountain pen has a different structure to that of a typical ballpoint pen. Similarly, the performan- ce of scrivo.1 greatly depends on how you hold it. As a result, when you try to write a memo or draw a simple graph with scrivo.1, holding it incorrectly may result in unexpected output such as rotated letters, tilted axis and so on. Therefore, you should be careful when you hold scrivo.1
.
The Ccorrect way to hold scrivo.1 is shown in the pictures below. The forepart, where the push button is attached, should face the front
Power switch
Turn the power ON/OFF using this switch located on the bottom of the pen. Power switch must be in the ON position before use. Switch to the OFF position if it’s not in use for a long period of time.
Pairing Button
Reset the pen to initial stage. After successful initiation, Status LED light will blink green continuously.
First button
Located on the end of scrivo.1 and has same function as the left button on a typical mouse.
Second button (Jog button)
Located on the front top of the pen and has same function as the right button on typical mouse. When you scroll the Jog switch, it will work like the mouse wheel scroll feature.
1) Green LED
-Blinking continuously: Initiating stage for pairing. (Blinking for the first 3 mins remain lit after 3 mins)
-No LED light: Complete Pairing Status.
-Continues to blink in
2) Red LED – Check battery status
- Need to recharge scrivo.1 when red LED blinks (continues to be usable for 30 mins)
Battery indicator
Red LED during charging and green LED when fully charged. Total charging time: 3.5 hours.
Front View | Side View |
If the angle of scrivo.1 and the surface is too low as shown in the figure (a), or if its forepart does not face to the front as shown in the figure (b), (c), and (d), it will not perform correctly.
(a) Angle of pen and surface | (b) scrivo.1 is turned to right. |
is too low. |
|
(c) scrivo.1 is reversed. | (d) scrivo.1 is turned to left. |
6 | 7 |
