Safety Warnings and Precautions, General | Polaris P2000i specs

SAFETY

Safety Warnings and Precautions

IMPORTANT SAFEY INSTRUCTIONS. SAVE THESE INSTRUCTIONS.

Failure to follow recommended precautions and procedures could result in severe injury or death. Always read all safety precautions and follow all operation, inspection, and maintenance procedures outlined in this manual.

General

•Read and understand all of the safety and operating information in this manual and on the product before using the machine. Use the generator only as described in this manual.

•Understand and follow all inspection and maintenance procedures outlined in this manual. Following these procedures will ensure that the generator remains in safe operating condition.

•Turn off the petrol valve and close the fuel cap vent when the generator is not in use.

It is the responsibility of the owner to ensure that all users of this generator are fully informed of the safety and operating information prior to use.

Before and During Operation

•Preform all Pre-Inspection activities as shown on page 25 of this manual. Inspect and tighten all parts regularly. Ensure the generator does not have any damaged, loose, or missing parts before use. All defects should be corrected before use. Do not operate the generator if it has been dropped or damaged until all defective parts have been repaired.

•Do not place any flammable materials near the generator.

•Never start the generator or let it run in an enclosed area. Exhaust vapors are poisonous and can cause loss of consciousness or death in a short time. Keep the generator away from buildings and other equipment during operation.

7

Image 8

Polaris P2000i, P1000i manual Safety Warnings and Precautions, General, Before and During Operation

Contents

Polaris Power Table of Contents Introduction Welcome Intended Use Safety Precautions Signal Words and Safety Terms Alcohol or Drug USE Identification Numbers and Locations P1000iP2000i Safety Safety Warnings and PrecautionsGeneral Before and During Operation Fire Safety Operator Safety Fuel Safety Carbon Monoxide Safety Electrical Safety Extension Cord Information Equipment Modifications Safety Labels and Locations Carbon Monoxide WarningOutdoor Use only Danger Label Hot Exhaust Caution Safety Controls and Features Generator Components Control Panel Components P1000i P2000i Engine Fuel Switch Choke LeverFuel Tank Cap Vent Lever Starter Recoil Grip Smart Throttle Switch DC Receptacle and Fuse AC Receptacles Indicator PanelGround Terminal Overload Protector Reset Switch Parallel Receptacles First USE Instructions Adding Engine Oil Fuel Recommendation Adding Fuel Pre-Operation Checklist PRE-OPERATION Inspection Safe Operating Precautions OperationFuel Recommendations Refueling Remove the fuel tank cap a Before Starting the Engine Starting the Engine Position the engine switch to on Stopping the Engine AC Operation AC Capacity Wattage Reference Table Power Management DC Operation Operation Disconnecting the Battery Charging Cable Smart Throttle System Standby Power Connections to a Building Electrical System Parallel operation procedure Parallel Generator Operation Shutting off the generators High Altitude Use Carburetor Modification Alterations Emission Control System InformationSource of Emissions Problems Affecting Emissions Replacement Parts Maintenance Importance of Maintenance Maintenance Safety Safety Precautions Periodic Maintenance Periodic Maintenance Chart Opening the Service Door Initial Maintenance Fuel SystemHour Initial Break-In Fuel Line Inspection OFF Oil Level Inspection Engine OilOil Recommendation Oil Change Procedure Maintenance Air Filters Air Filter Inspection Air Filter Cleaning Air Filter Replacement Spark Plug Inspection and Replacement Spark Plug Gap should be 0.6 0.7 mm Transporting the Generator Transportation and StorageTransportation Storage Storage Preparation Accessing the Fuel Tank Draining Fuel from the Fuel Tank and Carburetor Fogging the Engine Storage Precautions Removing from Storage Specifications General Specifications Polaris Lubricants and Maintenance Products Modified coefficient table of ambient condition power Wiring Diagrams P1000i Wiring Diagram P2000i Wiring Diagram Red Gray Brown White Black Troubleshooting Troubleshooting SymptomsEngine Will Not Turn Over Engine Turns Over, but Will Not Start Engine Lacks Power Engine Backfires Engine Pings or Knocks Engine Runs Irregularly, Stalls, or Misfires No Power at DC Receptacle Possible Lean Solution Fuel Cause No Power at AC Receptacles Engine Stops or Loses Power Warranty About this Warranty Document Warranty Registration Form Warranty Period Warranty Exclusions Polaris Power Generator Owner Responsibility Important Notice Maintenance LOG DATE/HOURS Service Comments Supplier Permormed Technician Index Label Location Index PMS