Polaroid SprintScan 45 manual Tu rning on the scanner

Scanner and another

unterminated device

Place the scanner at the end of the chain and use the termina- tor provided. Do not add any additional terminators. If one external device has an internal terminator, see the previous example. Use only approved SCSI cables.

Tu rning on the scanner

1With the scanner off, plug the power cord provided into the scanner (picture 4), and then into an appropriate grounded outlet. The scanner can operate over a voltage range from 100 to 240 VAC.

2Turn on the scanner; the switch is next to the power connector. The POWER indicator light on the front of the unit will light, the cold cathode lamp will come on (visible through the slit on the top of the unit), and the READY indica- tor will flash briefly. The scanner will perform a self-test that lasts for a few seconds. If no problems are detected, the READY light will stay lit. The cold cathode lamp will also stay on.

3Once the ready light is lit, turn on your computer.

4

Setup and use 2-9