Polycom 6000, 7000 manual Multicast Routing Source Menu

Multicast Configuration 183

Configur- ing PIM— Dense Mode by Port

Managing

Multicast

Route

Source

Type P to configure Protocol-Independent Multicast (PIM) version dense mode by port and interface.

1.The IAD displays the available interfaces and a prompt:

Available Interfaces:

1.G2237 xDSL

2.10/100BaseT Ethernet

0.(Abort)

Selection:

Type the option number to select the interface.

2.The IAD displays the port table for this interface and prompts for a port.

Port VPI VCI		Encapsulation Type	PCR	Service
1	0 40	RFC 1483 (with LLC Encap)3641		UBR
		Total = 3641 cps

Maximum PCR this interface can support = 3622 cps Select Port: [1-8]

Type the port to configure and press Enter.

3.The IAD displays the PIM status for this port and a prompt:

PIM-DM over G2237 xDSL Port 1 is currently DISABLED Enter E to Enable, D to Disable:

Type E to enable PIM on this port, or type D to disable it.

4.The IAD saves the new configuration and displays the Multicast Configuration menu.

5.Reset the IAD (page 15) for changes to take effect.

Reverse Path Forwarding (RPF) checks the IP address of the sender of the packet and then finds the best outgoing interface from its normal IP routing table.

Type S to add or change the Multicast Route Source. The IAD displays the Multicast Routing Source menu:

Figure 10–2. Multicast Routing Source Menu

*******************************************

Multicast Routing Source Menu

*******************************************

A. Add a Multicast Routing Source

R. Remove a Multicast Routing Source

S. Show Multicast Routing Source

NetEngine IAD User Guide