Specifications | Powermatic PM1500 specs

6.0Specifications

Model number	PM1500
Stock number	1791500
Motor and electricals:
Motor type	totally enclosed fan cooled, induction, capacitor start
Horsepower	3 HP
Phase	single
Voltage	230V
Cycle	60Hz
Listed FLA (full load amps)	12A
Starting amps	55A
Running amps (no load)	3.3A
Start capacitor	200MFD, 250VAC
Run capacitor	60µF, 300VAC
Power transfer	Poly-V 9 groove belt drive
On/off switch	Magnetic, with power indicator lamp and safety key
Motor speed	1720 RPM
Blade speed	3100 SFPM
Power cord length	6.6 ft. (200cm)
Power plug installed	yes
Recommended circuit size 1	20A
Sound emission	72 dB at 39” (1000mm) from blade, without load

1subject to local and national electrical codes.

Capacities:
Maximum cutting height/resaw capacity	....................................................................................... 14” (355mm)
Throat capacity	14-1/2” (368mm)
Minimum blade width	1/8” (3.2mm)
Maximum blade width	1” (25.4mm)
Blade length 2	153 +/-1/2” (3886mm)
Blade provided	hook type, 3/8” x 0.065” x 6 TPI
Wheel diameter	15” (381mm)

2blade length range is 152-1/2” to 153” for band saws with serial no. 12100002 to 12100052.

Miscellaneous:
Fence plate	19-3/4”L x 6-1/2”H (502 x 165mm)
Resaw pin	1-1/2” dia x 6-1/2”H (38 x 165mm)
Stand footprint	17-3/4”L x 25-1/4”W (450 x 641mm)
Overall dimensions, assembled	30-1/4”L x 34-3/8”W x 80-1/4”H (768 x 873 x 2038mm)
Miter gauge positive stops	45°, 90°
Materials:
Table	ground cast iron
Trunnion	cast iron
Enclosed cabinet	steel
Band wheels	cast iron
Tires	polyurethane
Blade guides	ball bearing
Resaw fence	extruded aluminum
Handwheels	cast iron, chrome finish
Paint finish	powder coat
Table:
Table dimensions	21-1/2”L x 16”W x 2”Thk (546 x 406 x 51mm)
Table tilt	10° left, 45° right
Table height from floor at 90-degrees	40” (1016mm)
Miter T-slot	7/8”W x 3/8”D; opening 3/4"W (22 x 9.5; 19mm)
Edge bevel	front