Powerware 2500 manual UPS Wire Function, Function Position EUH Models, Size Rating Torque

INSTALLATION

5.Insert each conduit through a wiring access entry and attach the conduit fitting to the panel. Strip 1.5 cm (0.5I) of insulation from the end of each incoming wire.

6.Connect the input and ground wires to the input terminal block according to Figure 22 and Table 1.

7.Connect the output and ground wires to the output terminal block according to Figure 22 and Table 1.

				INPUT			OUTPUT
			1	2	3	4	5	6
			Figure 22. Terminal Block
Table 1. UPS Wiring Specifications
Wire	Terminal	UPS Wire Function				Terminal Wire			Tightening
Function	Position	EUH Models	EH and GH Models				Size Rating*		Torque
Input	1	L2	N
							2–10 mm2
	2	G	G						4.38 Nm (35 lb in)
							(14–8 AWG)
	3	L1	L
Output	4	L2	N
							2–10 mm2
	5	G	G						4.38 Nm (35 lb in)
							(14–8 AWG)
	6	L1	L

*Use 2.0 mm2 (14 AWG) 75_C copper wire minimum.

8.Reinstall the terminal block cover.

9.If an emergency power-off (disconnect) switch is required by local codes, see “Remote Emergency Power-off Installation” on page 31 to install the REPO switch before powering on the UPS.

EATON Powerware® 9125 Two-in-One UPS (2500/3000 VA) User’s Guide S 164201374 Rev D	29
www.powerware.com