Powerware 2500 manual Turning the UPS On, Starting the UPS on Battery

Chapter 4 Operation

This section describes:

STurning the UPS on and off

SStarting the UPS on battery

SInitiating the self-test

SOperating modes

Turning the UPS On

After the UPS is connected to utility power, it conducts a self-test and enters Standby mode.

To turn on the UPS, press the On button on the front panel. The

μindicator illuminates solid and the bar graph indicators display the percentage of load being applied to the UPS.

Starting the UPS on Battery

To turn on the UPS without using utility power, press and hold the

On button for at least four seconds. The UPS starts up in Battery mode and supplies battery power to your equipment. When the UPS starts on battery, it does not conduct a self-test to conserve battery power.

EATON Powerware® 9125 Two-in-One UPS (2500/3000 VA) User’s Guide S 164201374 Rev D	35
www.powerware.com