Installation

3.The equipment to be protected by the UPS should be powered off. Plug the equipment into the power output receptacles on the UPS rear panel.

DO NOT protect laser printers with the UPS because of the exceptionally high power requirements of the heating elements. The optional PowerPass has a surge-protected receptacle for laser printers.

4.Turn on the equipment that is connected to the UPS.

5. Press and hold the Output On button until you hear the UPS beep (approximately one second).

The •indicator remains lit and the Self Test indicator turns on. The front panel displays the percentage of full load being applied to the UPS. The UPS is now in Normal mode with the load online. See “Normal Mode” on page 36 for more information.

UPS Startup for 208V-240V Models

To start up the UPS for 208V, 220V, 230V, or 240V models:

1.Steps 2 through 7 are for changing the output voltage. The output voltage is factory-configured for 230V. If you do not need to change the output voltage, skip to Step 8.

2.Plug the UPS power supply cord into the input connector on the UPS rear panel.

3.Press and hold the Output Off button while plugging the other end of the power supply cord into a grounded, three-wire, AC receptacle that has been wired in accordance with national wiring rules.

Release the Output Off button when the alarm beeps. All indicators flash simultaneously.

32

Powerware® 9 Prestige Series User’s Guide (600 VA - 1800 VA) : www.powerware.com