C H A P T E R 4
REMOTE CONFIGURATION
Use the following procedure to access the card’s configuration program through a Web browser.
NOTE Verify that an active 10/100BaseT cable is connected to the card’s network connector (the Uplink Ethernet connector on the
Add a Routing Condition in the Computer
If the IP address of the computer is on the same network with the ConnectUPS Web/SNMP Card, you may just run the Web browser directly.
If the IP address of the computer is not on the same network with the ConnectUPS Web/SNMP Card (only required while configuring the card), you can use the Add Routing command.
1.Turn on the computer and set up the TCP/IP protocol if needed.
2.Enter the following command to add a routing condition:
Route add 192.168.7.18 192.72.173.20where 192.168.7.18 is the default IP address of the card and 192.72.173.20 is an example IP address for the computer.
NOTE Refer to your operating system documentation for additional details on how to add a routing condition.
ConnectUPSZ Web/SNMP Card (X and BD Models) User’s Guide : Rev A www.powerware.com | 17 |