Local Configuration
3.Open your terminal emulation program such as HyperTerminal and select the appropriate serial connection (such as COM1).
The serial line should be set to 9600 baud, No parity, 8 data bits, 1 stop bit, and no flow control.
4.Verify that the UPS is turned on.
5.After a few seconds, press [Enter]. The Password screen appears (see Figure 5).
If the screen does not appear, press [Enter] again.
If you still do not see the Password screen, check the following conditions:
:Verify the serial line is set to 9600 baud, No parity, 8 data bits, 1 stop bit, and no flow control.
:If the serial line settings are correct, check the cabling to verify all connections are secure.
:Verify that your terminal program is on the correct communication port for the serial connection.
:Verify that the ConnectUPS Web/SNMP Card has power (one or more LEDs on the card should be illuminated). The UPS should be turned on.
6.Type your password (the default password is admin) and press [Enter]. The Main Menu screen appears.
+===================================================================
[ ConnectUPS Web/SNMP Card Configuration Utility ]
+=================================================================== Enter Password: *****
+===================================================================
[ ConnectUPS Web/SNMP Card Configuration Utility ]
+===================================================================
1.Web/SNMP Card Settings
2.Reset Configuration to default
3.Restart Web/SNMP Card
4.UPS
0. Exit
Please Enter Your Choice =>_
Figure 5. ConnectUPS Web/SNMP Card Main Menu Screen10 | ConnectUPSZ Web/SNMP Card (X and BD Models) User’s Guide : Rev A www.powerware.com |