C H A P T E R 2
INSTALLATION
With the
To install the ConnectUPS Web/SNMP Card, perform the following steps:
1.Verify that both DIP switches on the card are set to the 0 (off) position.
2.Remove the
NOTE If there is another card already installed with an attached communication cable, disconnect the cable and then remove the card.
3.To prevent electrostatic discharge (ESD), place one hand on a metal surface such as the UPS rear panel.
Slide the ConnectUPS Web/SNMP Card into the open slot and secure with the screws removed in Step 2.
0 1
4.Connect an active 10/100BaseT cable to the Uplink Ethernet connector on the
NOTE Three additional 10/100 Mb Ethernet connectors are available on the
ConnectUPSZ Web/SNMP Card (X and BD Models) User’s Guide : Rev A www.powerware.com | 5 |