Precor manual EFX5.21/ 5.23 Elliptical Fitness CrossTrainer Assembly Guide

Before exercising, make sure the EFX is level and does not wobble from side to side.

Important: If the EFX is placed on a slightly uneven surface, turning the leveling pads can help, but will not compensate for extremely uneven surfaces.

1.Kneel by the side of the stabilizer and lift the base slightly so you can access the levelers.

2.Rotate the levelers as needed.

3.When the EFX is level, fully tighten the lock nut and lower the EFX to the floor.

Connect the power cord.

CAUTION: Use the supplied power cord. Do not remove or otherwise bypass the 3-prong plug with an adapter in order to use a non-grounded outlet. Do not plug the EFX into a power transformer in an attempt to adjust the voltage requirements. Failure to follow these instructions might damage the unit and will void the Precor Limited Warranty.

1. Insert the power plug connector into its receptacle at the rear of the unit.

2.Plug the other end into a grounded outlet so you can maintain a consistent power source without overloading any other circuitry. Be sure to use the appropriate voltage. Refer to Grounding Instructions in the owner’s manual.

Turn the unit On.

Use the power switch to turn the unit On. Check that the Precor banner appears on the display. If the display remains blank, cycle the power. If the display continues to remain blank, check the cable connections.

Important: Make sure the locking pin is removed and stored before you begin exercising.

EFX5.21/ 5.23 Elliptical Fitness CrossTrainer Assembly Guide 8