Precor C966 owner manual Attach

C O M M E R C I A L P R O D U C T S D I V I S I O N

Diagram 7	Attach the
	display console
	to the left upright
	support.
	Display console
	Display cable
	Screws (A) with
	washers (B)
	Left side
	upright support

CAUTION:To avoid damage to the display cable, read the following steps carefully. Damage to the cable due to improper assembly is not covered by the Precor limited warranty.

6.Secure the display console to the left upright support. Diagram 7. Remove any tape or wire ties that secure the display cable. Unwrap the cable to remove kinks. Ask an assistant to hold the display console in place while you attach it to the left upright support using two buttonhead screws (A) with washer (B). Finger tighten.

Diagram 8	Remove right
	side front panel
	screws.
	Right side
	mounting bracket
	Front panel
	fasteners

7.Prepare to attach the right side upright. Diagram 8.Take the following steps:

a.Remove the shipping fasteners from the right front panel. Follow the same process as in step 5a. With the supplied hex key and a ¹⁄₂-inch box end wrench, loosen and remove the two bolts and nuts on the right side of the front panel.

page 13