C O M M E R C I A L | P R O D U C T S | D I V I S I O N |
Diagram 6 Route the cable | 1 | 2 |
through the grommet | ||
and attach the upright |
|
|
support. |
| Upright |
Base tube |
| support |
Cable receptacle |
|
|
Cable connector |
|
|
Have your assistant |
|
|
hold the upright |
|
|
support while you |
|
|
secure it to the base. |
|
|
Two bolts (G) with |
|
|
washers (H) |
|
|
|
| Base |
|
| assembly |
8.Position the upright support over the base. Diagram 6. Have your assistant move the upright support close to the front of the base assembly while you thread the cable through the grommet hole and out the front of the base tube (see inset #1). Make sure that the display console (on the upright support) faces the rear of the unit (see inset #2).
CAUTION: As you assemble the unit, do not fully tighten the fasteners until instructed to do so. Finger tighten the fasteners or use the hex key so that the unit is stable, but the fasteners still allow room for adjustments.
9.Secure the upright support to the base assembly. Diagram 6. Align the mounting holes and thread the two bolts (G) with washers (H) through opposite sides of the upright support and into the base assembly. Finger tighten each bolt. Do not fully tighten the fasteners until the entire unit has been assembled.
Diagram 7 Connect the cables.
Cable receptacle
Cable connector
Height adjuster threads
Base tube
Place excess cable into the base tube.
page 13
