ASSEMBLY

To hire a service technician to assemble this prod- uct in your home, call 1-800-445-2480.

Assembly requires two persons.

Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until you finish all assembly steps.

The underside of the walking belt is coated with high-performance lubricant. After shipping, there may be some lubricant on top of the walking belt or on the shipping carton. This is normal. If there is lubricant on top of the walking belt, wipe it off with a soft cloth and a mild, non-abrasive cleaner.

To identify small parts, see page 6.

Assembly requires the following tools:

the included hex keys

one Phillips screwdriver

scissors

To avoid damaging parts, do not use power tools.

1. Make sure that the power cord is unplugged.

1

 

Remove and discard the two screws (A) and the

 

shipping bracket (B) from the right side of the

 

Base (74). Then, remove and discard the screws

 

and shipping bracket (not shown) from the left

B

side of the Base.

 

A

 

74

2. Locate the Upright Wire (63) bundled between

2

the Base (74) and the Belly Pan (52). Route the

Upright Wire into the Base and out of the indi-

 

cated hole.

 

Press a Base Cap (70) into each side of the

Base (74).

See the inset drawing. Cut the plastic tie near

 

 

the Upright Wire (63). Be careful not to dam-

52

74

age the Upright Wire.

 

 

 

70

Tie

63

Cut

Hole

 

 

63

 

 

7

Page 7
Image 7
ProForm Lwufp user manual Assembly, Make sure that the power cord is unplugged, Age the Upright Wire