Chapter 2: Installation
13
• Fast Init erases the Master Boot R ecord (MBR) of the physical drives
when this feature is set to ON.
• Stripe Block Size. Press the Spacebar to toggle through 32 KB, 64 KB,
or 128 KB. 64 KB is the default. Applies to RAID 0.
7. Press the arrow keys to move to Disk Assignments. Press the spacebar to
toggle between N and Y for each available drive. Y means this physical drive
will be assigned to the logical driv e.
Assign the appropriate number of physical drives to your logical drive.
8. Press Ctrl-Y to save your logical drive configuration.
9. If you set Fast Init to ON, the following message displays:
• Press Ctrl-Y to continue logical drive creation and perform the Fast
Initialization.
• Press any other key to cancel logical drive creation.
If you set Fast Init to OFF, the following message displays:
Press N to finish logical drive creation.
10. Press Esc to exit to the Main Menu. Press Esc again to exit the Utility.
11. Press Y to restart the computer.
You have successfully created a new RAID logical drive.
Important
You must be partition and format your new logical drive before you
can use it. Use the same method of partitioning and formatting a
logical drive as you would any other fixed disk added to your
computer system.