CONNECTING THE SCSI CABLES

Installation of the UltraTrak100 disk array is very similar to the installation of a standard SCSI drive. The SCSI connector accepts the standard 68-pin LVD SCSI connector used on most LVD SCSI devices. Refer to your system and/or SCSI host adapter manual for additional installation procedures that may apply to your system or host adapter.

 

SCSI-IN

COM-1

 

 

SCSI Connector Input

SCSI-OUT

 

 

/TERM

 

SCSI Connector

 

 

Output/Terminator

 

 

Power Switch

 

 

O

I

 

 

 

115

Voltage Select Switch

 

 

Figure 2. Back of UltraTrak100 TX4 (see Figure 8 for TX8)

Caution

To prevent possible damage to the array or system, ensure that system power is OFF before connecting the cables.

SCSI CABLE CONNECTION AND TERMINATION

Two 68-pin wide SCSI connectors are provided on the back of the enclosure for connecting the array to the system. These connectors are used in one of two ways:

If the UltraTrak100 disk array is the only external SCSI device, or is the last external device in a daisy-chained configuration, connect the incoming cable

5

Page 11
Image 11
Promise Technology user manual Connecting the Scsi Cables, Back of UltraTrak100 TX4 see for TX8