LCD Messages, Error Mode, Array Functional | Promise Technology TX4

THE LCD MESSAGES

The UltraTrak100 LCD message display panel has the following modes of operation:

•Idle mode

•Error mode

•Configuration mode

Idle Mode

Error Mode

Provides an error message

See below

Configuration Mode

View Status

Configure Array

Configure Cache

Configure SCSI

IDLE MODE

See page 20

See page 21 See page 24 See page 32 See page 33

The Idle mode message, such as shown below, is displayed during normal operation of the UltraTrak100 when there are no problems or buttons being pressed:

		Array Functional					Array status may be:
		Array Functional					Array status may be:
		30°C/86°F	4500RPM			!		Array Functional
						!		Array Critical
						!		Array Critical
What you can do:						!		Array Offline
What you can do:
		Press SEL:		Press to enter Configuration menu.
		Press	:	Press to enter Configuration menu.
		Press	:	Press to enter Configuration menu.
		Press	:
		Press EXIT:		Press to enter Configuration menu.

19

Image 25

Promise Technology TX4, TX8 user manual LCD Messages, Error Mode, Configuration Mode, Array Functional, 30C/86F 4500RPM

Contents

ULTRATRAK100 TX4 ULTRATRAK100 TX8 Trademarks CopyrightImportant Data Protection Information Radio Frequency Interference Statement Table of Contents RAID Page Architectural Description Introduction Feature Benefit Features and Benefits Configuration Install Hard DrivesGetting Started Unpack ULTRATRAK100 UltraTrak100 Disk Drive Access TX4 Shown Back of UltraTrak100 TX4 see for TX8 Connecting the Scsi Cables Daisy Chaining Several UltraTrak100s Together Assign a Scsi ID Connect Power Cable and Switch Power on Configure the ULTRATRAK100 Press SEL to Save Changes Advantages Disadvantages Choosing a RAID Level RAID 0+1 Characteristics/Advantages Disadvantages Jbod Partition and Format the Array Drive Status Indicators MaintenanceIndicator Color Meaning Critical & Offline Arrays When a Disk Drive Fails REBUILDING/SYNCHRONIZING Fault Tolerant ArraysReplacing a Disk Drive Module Drive Carrier Drive Replacement Replacing a Power Supply Module TX8 only Connecting Cables to Disk Drive Back of UltraTrak100 TX8 Type of Interface Name Comments ULTRATRAK100 Front Panel Interface Configuration Mode Error ModeLCD Messages Array Functional Configure Scsi View Status Configure Array Configure CacheView Status View Cache Stats View Controller InfoView Array Information View Enclosure View Controller Information Array 0 Size 12GB Temperature 30C/86FRAID 0 Functional 5009 RPM Create/Cancel Press SEL to Create Press Exit to Cancel What you can do Auto Array SetupView Drive Assignments Define Array Delete Array Maxtor Asng In Ary IBM Asng In Ary No Free Disk What you can do RAID Level 4KB 8KB IBM Assigned Maxtor Free Maxtor Free Wipe out disk Synchronize Array Disable Buzzer Rebuild/Sync Pri. Low Array ID Write Cache What you can do Write CacheWrite Back Write Thru What you can do Write Back ID Selected Mode Press Or to move these items on the LCD What you can do Scsi ID Contacting Promise Support Technical Support ServicesUSA Tech Support Center European Tech Support China Office Pacific Rim Sales Office Disclaimer of Other Warranties Limited WarrantyPage Returning Product for Repair USA & Canada Your Responsibilities Introduction to RAID Appendix a Technology Background RAID 1 Mirroring RAID 0+1 STRIPING/MIRROR RAID 3 Block Striping with Parity Drive RAID 5 Block and Parity Striping Jbod Spanning Appendix B Frequently Asked Questions Why can’t I see the drives on the UltraTrak100 under FDISK?