6–iSCSI Noninteractive Commands
-pdt
6-20 SN0054667-00 C
This command is not active for the PPC.
For information on secondary boot code, see “-sbootcode (Set Secondary Boot
Target Information)” on page 6-24.

-pdt

To disable a target, issue the -pdt command as follows:
-pdt <hba_port_inst> <targetId>

-pet

To enable a target, issue the -pet command as follows:
-pet <hba_port_inst> <targetId>
-pinfo

(Port Information)

To view port information for the specified adapter, issue the -pinfo command as
follows:
-pinfo <hba_port_inst>

-ping

(Ping Target)

To ping the target device, issue the -ping command as follows:
-ping <hba_port_inst> <IP Address> <Ping Count> <Packet size>
<IPv6 source address>
The following provides the IPv6 source address values:
Where:
0 = Do not care
1 = Local link
2 = Address 0
3 = Address 1
hba_port_inst =The adapter port that sends the ping
IP Address =The IP address to ping
Ping Count =The number of ping packets you want (1–[231]).
Packet Size =The size of the ping packet 0–64kB
IPv6 Source Address =Origin device