Q-Logic manual -l

5–Fibre Channel Noninteractive Commands
-l (Display LUN Info)
5-22 SN0054667-00 C
If the read/write buffer test fails, the system shows the following information:
Loop/port ID (the loop ID of the adapter when operating in loop mode).
Status:
Success—The test passed.
Error—A data miscompare or link status firmware error occurred.
Failed—A link status error, SCSI write buffer error, or SCSI read buffer
error occurred.
Unknown—The target was not present.
Unsupported—The device does not support this test.
Data Miscompare—The possible values are:
0 (no data miscompares)
Device not present
Get link status failed
Read buffer failed
R/W buffer not supported
Write buffer failed
Link Failure—Number of link failures
Loss of sync—Number of sync loss errors
Loss of signal—Number of signal loss errors
Invalid CRC—Number of invalid CRCs
-l
(Display LUN Info)
This command shows LUN information for:
All adapters
A specific target
A specific LUN on a specific target
To show the LUN information for all target devices for a specific adapter Instance,
issue the following command:
#qaucli -pr fc -l (<hba instance> | <hba wwpn>)
To show the LUN information for a specific device for a specific adapter port, issue
the following command:
#qaucli -pr fc -l (<hba instance> | <hba wwpn>) (<target port
id> | <target wwpn>)