Q-Logic QLA2300 manual Restore Default Settings, Raw Nvram Data, Advanced Adapter Settings

A – Fast!UTIL Configuration Settings

Some new system BIOSs support selectable boot, which supersedes the Fast!UTIL selectable boot setting. To boot from an FC hard disk attached to the QLA23xx board, select the QLA23xx board FC hard disk on the system BIOS.

NOTE: This option applies only to hard disks; it does not apply to tape drives and other nondisk devices.

A.2.3

Restore Default Settings

The Restore Defaults option from the Configuration Settings menu restores the QLA23xx board default settings.

A.2.4

Raw NVRAM Data

This option displays the adapter’s NVRAM contents in hexadecimal format. This is a QLogic troubleshooting tool; you cannot modify the data.

A.2.5

Advanced Adapter Settings

From the Configuration Settings menu in Fast!UTIL, select Advanced Adapter Settings. The default settings for the QLA23xx board are listed in table A-2and described in the following paragraphs.

Table A-2. Advanced Adapter Settings

Setting	Options	Default
Execution Throttle	1–256	16
Fast Command Posting	Enabled, Disabled	Disabled
>4GByte Addressing	Enabled, Disabled	Disabled
Luns per Target	0, 8, 16, 32, 64, 128, 256	8
Enable LIP Reset	Yes, No	No
Enable LIP Full Login	Yes, No	Yes
Enable Target Reset	Yes, No	No
Login Retry Count	0–255	8
Port Down Retry Count	0–255	8
Drivers Load RISC Code	Enabled, Disabled	Enabled
Enable Database Updates	Yes, No	No
Disable Database Load	Yes, No	No
IOCB Allocation	1–512 buffers	256 buffers
Extended Error Logging	Enabled, Disabled	Disabled

FC2251101-00 D A-3