QLOGIC SWITCH INTEROPERABILITY GUIDE PAGE 149
VERSION 1.0, MARCH 2003
INRANGE FC/9000 Switch
Integration Checklist
The following steps must be completed to successfully merge INRANGE and QLogic fabrics. The
remainder of this section provides detailed instructions and examples.
ATTENTION!!
■Backup the current configuration prior to performing the following steps so that the
configuration is available if something goes wrong.
■Disruptions in the fabric can occur as a result of performing the following steps. Therefore,
it is recommended that these changes be done during down time or off-peak hours.
✓Verify that the correct version of switch firmware is installed on each switch (see“Supported
Switches and Firmware Versions” on page150).
✓Ensure that each switch has a unique Domain ID and that it falls within the proper range
(see “Domain ID Configuration” on page150).
✓Set all switches to the appropriate timeout values (see“Timeout Values” on page155).
✓Ensure that all Zone set and Zone names are unique and conform to ANSI T11 standards
(see “Active Zone Set Names” on page161).
✓Ensure that the zone member type is set to Port WWN (see “Zone Types” on page171).
✓Verify that the fabrics have successfully merged (see“Successful Integration Checklist” on
page 179).