Quadra-Fire 21M-ACC owner manual Appliance Set-Up, Millennium Wood Stove ACC, Door Handle Assembly

			R		2100 Millennium Wood Stove (ACC)
A.7			Appliance Set-Up
	Door Handle Assembly			B. Adjusting The Blower Speed Control
1.		Install washer on door handle shaft.		The blower speed control for this unit is adjusted at the factory,
				and normally does not require further adjustment.
2.		Slide door handle through door.
				NOTE: When the speed control is turned clockwise,
3.		Install second washer(s) as shown in Figure 19.1.
					it will click on to high speed. Continue to turn the
4.		Install key in groove.
					speed control clockwise to decrease the speed. At
5.		Align groove in latch cam with key; slide latch cam			full clockwise, the blower should blow gently, but
					should not stop.
		over shaft
				1. With the appliance plugged in, turn the speed
6.		Install locknut but do not overtighten, the handle
					control knob to slow (full clockwise).
		needs to move smoothly.
				2.	With a small screwdriver, adjust the blower speed
7.		Install spring handle turning in a counter-clockwise
					by turning the adjustment mechanism through the
		motion to required 2 inch (51mm) clearance loca-
					hole on the side of the speed control.
		tion on door handle rod. Figure 19.1.
				3. Adjust the speed so the blower runs slowly, but
					does not stop. Turn clockwise to slow the blower
			CAUTION		and counterclockwise to increase the speed.

•Do NOT overtighten lock nut.

•Door handle needs to move smoothly.

	2 inch (51mm) clearance
	required from bend in door
	handle rod to end of spring
	handle.
	Door Cross Section
Latch Cam	(example)

Locknut

Spring

Handle

Spacing	Door Handle
Washers	Square Key

Figure 19.1

WARNING

HOT. Injury Risk.

•Maintain clearance between bend of door handle rod and spring handle.

•Spring handle will get hot and may cause injury.

May 5, 2011 7039-131H Page 19