Quadra-Fire 21M-ACC Millennium Wood Stove ACC, B. Outside Air Kit Installation, Cover Plate

2100 Millennium Wood Stove (ACC)

R

B. Outside Air Kit Installation

A source of air (oxygen) is necessary in order for combus- tion to take place. Whatever combustion air is consumed by the fire must be replaced. Air is replaced via air leakage around windows and under doors. In homes that have tightly sealed doors and windows, an outside air source is needed. An optional Outside Air Kit is available.

Included in OAK-ACC: Termination cap, (2) wire ties, flex adapter, and fasteners

Included in SRV7033-041:Cover plate and sealing rope (see Floor Installation Alternative below, Figure 12.2)

Items Needed for Installation (not supplied)

•4 inch flex aluminum pipe, or if using alternate material, then it shall be made from durable, non-combustible, heat resistant material up to 350oF. Cut the pipe to the required length for your installation.

•Phillips head screw driver

•Silicone sealant

•Drills and saws necessary for cutting holes through the wall or flooring in your home

WARNING

Fire Risk.

Asphyxiation Risk.

Do not draw outside combustion air from:

•Wall, floor or ceiling cavity

•Enclosed space such as an attic or garage

•Close proximity to exhaust vents or chimneys Fumes or odor may result

WARNING

Asphyxiation Risk.

Outside air inlet must be located to prevent blockage from:

•Leaves

•Snow or ice

•Other debris

Block may cause combustion air starvation

Smoke spillage may set off alarms or irritate sensitive individuals.

1.	Remove all materials from packing box.		WARNING
2.	Using a #2 Phillips screw driver attach the flex adapter to		Asphyxiation Risk.
			Length of outside air supply duct shall NOT exceed
	the stove using 4 screws. Figure 12.1.
3.	For floor installations, remove circular “knock-out” in the		the length of the vertical height of the exhaust flue.
			• Fire will not burn properly
	base of the pedestal. Figure 12.1.
			• Smoke spillage occurs when door is opened due to
4.	Floor & Rear Installation: Cut a 4 inch (102mm) hole in		air starvation.
	outside wall or floor to accommodate outside air piping.	5. Floor Installation Alternative: In some instances you
	Use 4 inch (102mm) aluminum metal flex or rigid piping
	to directly connect outside air to appliance intake. Use		may not be able to install the flex pipe as show in Figure
	the supplied termination cap with a rodent screen. Seal		12.1. If that is the case, you will need to order SRV7033-
	between the wall (or floor) and the pipe with silicone to		041 which includes a cover plate and sealing rope as
	prevent moisture penetration.		shown in Figure 12.2. The goal is to seal the pedestal
			so no room air can leak into the pedestal and to seal or

for cold air infiltration.

For Floor Installa- tions Remove Circular “Knock-Out” in Base of Pedestal.

Flex Adapter

Wire Tie

Termination

Cap

Flex Line Wire Tie

Cover Plate

Figure 12.1 - Floor & Rear Installation Figure 12.2 - Floor Installation Alternative

Page 12 7039-131H May 5, 2011