R

3100 Wood Stove Series (ACC)

Pedestal and Ash Removal System (Cont’d)

Installing Pedestal Assembly

1.Remove screws on adapter and slide pedestal over adapter on bottom of stove. Figure 22.1.

2.Line up holes in sides of pedestal with holes in adapter.

3.Securely tighten pedestal into place.

4.Carefully stand stove up and place in desired location.

5.Slip wooden decorative strips onto pedestal edges.

Finishing the ARS Installation

1.The ARS channel is already installed on the stove. Set the grate into the ARS channel and secure with 2 bolts previously removed. Replace the 2 front cut bricks. Figure 22.2.

2.Install the ash drawer.

3.Check to make sure baffle boards and ceramic blanket are in their proper locations (see page 28).

Grate

ARS

Channel

Replace both bricks

back into firebox

NOTE: If installing a floor installation of an outside air kit on a

Figure 22.2

 

 

Step Top model with a pedestal assembly you must attach

 

 

the enclosed cover plate to the back of the stove. Other

 

 

 

 

wise you may discard this piece. See Figure 22.3.

 

 

Adapters

Ash Removel

Drawer

Cover Plate

Figure 22.3

Oak

Pedestal

Trim

Figure 22.1

Page 22

7033-277C

March 2, 2007

Page 22
Image 22
Quadra-Fire 31M-ACC-NT, 31ST-ACC, 31M-ACC-GT, 31M-ACC-MBK Installing Pedestal Assembly, Finishing the ARS Installation