Installing Leg Kit | Quadra-Fire 31M-ACC-MBK, 31ST-ACC, 31M-ACC-GT

R

3100 Wood Stove Series (ACC)

B. Leg Kit and Ash Removal Installation (ARS) for Step Top Uni-Body

NOTE: The Ash Removal System, must be installed ﬁrst before installing the legs.

Begin installing the ARS System.

1. Follow steps 1 through 6 on page 21.

Installing Leg Kit

1.	Remove leg mounting brackets packaged inside ﬁrebox.
2.	Attach the 2 bottom screws of the mounting brackets to the
	bottom of the stove with 1/4”-20 Phillips screws. These screws
	are located in the component pack. Leave the bottom 2 screws
	loose so you can slide the ash pan assembly bottom slots over
	the screw heads. This allows the weight of the ash pan to
	rest on the screws while you are attaching the top 2 screws.

Lay stove flat on its back on protective padding or pallet

Leg Brackets

Ash Drawer

Insert 2 bottom screws loosely

	Once the ash pan is attached, tighten all screws.
3.	Loosely assemble bolts into the corner of the mounting brack-
	ets for leg attachment.
4.	Slide legs onto mounting brackets and tighten. Make sure the
	legs are up against the bracket. There are leveling bolts in 2
	legs. These leveling legs should be in opposite corners.
5.	Carefully stand stove up and place in desired location. Do NOT
	tilt up on the cast iron legs, it could damage the legs.
6.	Use leveling bolts on legs to stabilize and level stove.

Finishing the ARS Installation

1. Follow steps 1 through 3 on page 22. See also Figure 22.2.

Leg Mounting Brackets are

packaged inside firebox.

Leveling Legs at

opposite corners

Figure 23.1

Figure 23.2

CAUTION

Do NOT tilt the unit on the cast iron legs.

•Tilting could lead to property damage.

•Lift the unit upright and place it into position on the ﬂoor protector.

March 2, 2007

7033-277C

Page 23

Image 23

Quadra-Fire 31M-ACC-MBK, 31ST-ACC, 31M-ACC-GT Installing Leg Kit, Attach the 2 bottom screws of the mounting brackets to

Contents

Fire Risk Step Top Uni-Body Model Millennium ModelPedestal Model Shown Welcome to the Quadra-Fire Family Wood Stove Series ACC Table of Contents Mobile Home Approved Listing and Code ApprovalsBTU & Efﬁciency Speciﬁcations Appliance Certiﬁcation Any such action that may cause a ﬁre hazard Fire Risk Fire SafetyService / Maintenance Tip Asphyxiation Risk Wood Stove Series ACC Negative Pressure Appliance needs to draft properly for safety Inspect Appliance & Components and Pre-Use Check List Wood Stove Series ACC Flue Draft ConsiderationsVenting Systems Tools And Supplies Needed Masonry Chimney Wood Stove Series ACC Typical Stove Systems Millennium Model 3Dimensions and ClearancesAppliance Dimensions 34-1/4 in mm 457mm 14-15/16 19-1/16 in.379mm 484mm 33-1/8 Double Wall Pipe Wood Stove Series ACC Clearances to Combustibles UL and ULC See Figure InstallationHearth Protection Requirements Millennium Model Wood Stove Series ACC Step-Top Uni-Body Model Fire Risk Asphyxiation Risk Wood Stove Series ACC Outside Air Kit InstallationItems Needed for Installation not supplied Shock Risk Wood Stove Series ACC Blower Optional Venting Components Chimney Systems 5Chimney Requirements Solid Pack Chimney with Metal Supports as a Thimble ComponentsAir Clearances Instructions Chimney Height / Rise and Run Installing Chimney ComponentsSolid Pack Chimney with Metal Supports as a Thimble Cont’d Rule Wood Stove Series ACC Chimney Termination Requirements Part SRV7033-041 for installation in a mobile Home Mobile Home Installation Begin installing the ARS System 7Appliance Set Up Step Top model with a pedestal assembly you must attach Installing Pedestal AssemblyFinishing the ARS Installation Attach the 2 bottom screws of the mounting brackets to Installing Leg Kit Adjusting The Blower Speed Control Wood Stove Series ACC Door Handle Assembly Kindling or First Stage Operating InstructionsBurning Process Wood Selection & Storage Air Controls Automatic Combustion Control ACC Burn Rates and Operating Efﬁciency Wood Stove Series ACC Building a Fire Overﬁring Initial cold start-up and all Burn SettingsWood Stove Series ACC Blower Operating Instructions Opacity Smoke Issues Solutions Wood Stove Series ACC Frequently Asked Questions Disposal of Ashes General MaintenanceCreosote Chimney Cleaning ARS Operating and Cleaning Fire Risk Injury Risk Glass ReplacementGlass Cleaning Cleaning Plated Surfaces Brick Size Qty Wood Stove Series ACC Firebrick Replacement Bafﬂe Wood Stove Series ACC Bafﬂe Removal Snap Disc Replacement Replacing Tube Channel Assembly Wood Stove Series ACC Tube Channel Assembly ReplacementRemoving Tube Channel Assembly Diagnostic Question Possible Causes of Condition Solutions Troubleshooting Don’t get enough/any heat. What can I do about it? Exploded view Reference Materials Sizes Step Top Uni-Body Model Item # Accessories Wood Stove Series ACC Service Parts & Accessories Item # Service Parts Item # Service Parts Date of Service Performed By Description of Service Wood Stove Series ACC Service And Maintenance Log Wood Stove Series ACC Homeowner’s Notes Wood Stove Series ACC Homeowner’s Notes Cont’d Wood Stove Series ACC Warranty Policy Lifetime Warranty Contact Information Wood Stove Series ACC