Quadra-Fire 31M-ACC-NT Wood Stove Series ACC, D. Baffle Removal, E. Snap Disc Replacement

R

3100 Wood Stove Series (ACC)

D. Baffle Removal E. Snap Disc Replacement

1.Remove all ash from the firebox, and extinguish all hot embers before disposal into a metal container.

2.The baffle board has 2 pieces. With the ceramic blanket still in place, slide one baffle piece over the top of other one and pull out top piece through the door opening and then remove bottom baffle piece. Figure 34.1

3.Remove the ceramic blanket.

4.Re-install the baffle pieces one piece at a time. Be sure the baffle boards are even with the front manifold tube and is resting on all tubes. Figure 28.1 on page 28.

5.To re-install the ceramic blanket, it is easier to fold it in half first. Place on top of baffle board, open up and flatten and smooth out the blanket. Re-check the baffle board for correct positioning. Figure 34.2.

1.Locate the snap disc bracket assembly at the bottom left rear corner of the stove. Figure 34. 3

2.A magnet holds the bracket to the stove. Pull the bracket down away from the stove to expose the snap disc.

3.Pull the snap disc and spade connectors up and out of bracket as shown in Figure 34.4.

4.Using a Phillips head screw driver, remove the 2 screws from the snap disc and then remove the snap disc from the spade connectors. Replace with new snap disc and re-connect to spade connectors.

5.Push the snap disc and spade connectors back inside bracket and re-attach the bracket to the stove.

Figure 34.1 - Baffle

Snap Disc Location

Figure 34.3

Figure 34.2 - Ceramic Blanket

Snap Disc

Magnet

Spade

Connectors

Figure 34.4

Page 34 7033-277C March 2, 2007