Wood Stove Series ACC Door Handle Assembly | Quadra-Fire 31ST-ACC

R

3100 Wood Stove Series (ACC)

C.Door Handle Assembly

1.Install washer on door handle shaft.

2.Slide door handle through door.

3.Install second washer(s) as shown.

4.Install key in groove.

5.Align groove in latch cam with key; slide latch cam over shaft

6.Install locknut but do not overtighten as the door handle needs to move smoothly.

7.Install spring handle turning in a counter-clockwise motion to desired location on door handle rod.

CAUTION

•Do NOT overtighten lock nut.

•Door handle needs to move smoothly.

D. Adjusting The Blower Speed Control

The blower speed control for this unit is adjusted at the factory, and normally does not require further adjustment.

NOTE: When the speed control is turned clockwise, it will click on to high speed. Continue to turn the speed control clockwise to decrease the speed. At full clockwise, the blower should blow gently, but should not stop.

1.With the appliance plugged in, turn the speed control knob to slow (full clockwise).

2.With a small screwdriver, adjust the blower speed by turning the adjustment mechanism through the hole on the side of the speed control.

3.Adjust the speed so the blower runs slowly, but does not stop. Turn clockwise to slow the blower and counterclockwise to increase the speed.

	Door Cross Section
Latch Cam	(example)
Locknut
	Spring
	Handle
	Door Handle
	Spacing
	Washers
	Square Key

Figure 24.1

Page 24

7033-277C

March 2, 2007

Image 24

Quadra-Fire 31ST-ACC, 31M-ACC-GT, 31M-ACC-NT Wood Stove Series ACC Door Handle Assembly, Adjusting The Blower Speed Control

Contents

Step Top Uni-Body Model Millennium Model Pedestal Model ShownFire Risk Wood Stove Series ACC Welcome to the Quadra-Fire Family Table of Contents Listing and Code Approvals BTU & Efﬁciency SpeciﬁcationsAppliance Certiﬁcation Mobile Home Approved Fire Safety Service / Maintenance TipAsphyxiation Risk Any such action that may cause a ﬁre hazard Fire Risk Appliance needs to draft properly for safety Wood Stove Series ACC Negative Pressure Wood Stove Series ACC Flue Draft Considerations Venting SystemsTools And Supplies Needed Inspect Appliance & Components and Pre-Use Check List Wood Stove Series ACC Typical Stove Systems Masonry Chimney 3Dimensions and Clearances Appliance DimensionsMillennium Model 34-1/4 in mm 457mm 14-15/16 19-1/16 in.379mm 484mm 33-1/8 Wood Stove Series ACC Clearances to Combustibles UL and ULC Double Wall Pipe Installation Hearth Protection RequirementsMillennium Model See Figure Wood Stove Series ACC Step-Top Uni-Body Model Wood Stove Series ACC Outside Air Kit Installation Items Needed for Installation not suppliedFire Risk Asphyxiation Risk Wood Stove Series ACC Blower Optional Shock Risk 5Chimney Requirements Venting Components Chimney Systems Components Air ClearancesInstructions Solid Pack Chimney with Metal Supports as a Thimble Installing Chimney Components Solid Pack Chimney with Metal Supports as a Thimble Cont’dChimney Height / Rise and Run Wood Stove Series ACC Chimney Termination Requirements Rule Mobile Home Installation Part SRV7033-041 for installation in a mobile Home 7Appliance Set Up Begin installing the ARS System Installing Pedestal Assembly Finishing the ARS InstallationStep Top model with a pedestal assembly you must attach Installing Leg Kit Attach the 2 bottom screws of the mounting brackets to Wood Stove Series ACC Door Handle Assembly Adjusting The Blower Speed Control Operating Instructions Burning ProcessWood Selection & Storage Kindling or First Stage Automatic Combustion Control ACC Air Controls Burn Rates and Operating Efﬁciency Wood Stove Series ACC Building a Fire Initial cold start-up and all Burn Settings Wood Stove Series ACC Blower Operating InstructionsOpacity Smoke Overﬁring Wood Stove Series ACC Frequently Asked Questions Issues Solutions General Maintenance Creosote Chimney CleaningARS Operating and Cleaning Disposal of Ashes Glass Replacement Glass CleaningCleaning Plated Surfaces Fire Risk Injury Risk Wood Stove Series ACC Firebrick Replacement Brick Size Qty Wood Stove Series ACC Bafﬂe Removal Snap Disc Replacement Bafﬂe Wood Stove Series ACC Tube Channel Assembly Replacement Removing Tube Channel AssemblyReplacing Tube Channel Assembly Troubleshooting Diagnostic Question Possible Causes of Condition Solutions Don’t get enough/any heat. What can I do about it? Reference Materials Exploded view Sizes Step Top Uni-Body Model Wood Stove Series ACC Service Parts & Accessories Item # Accessories Item # Service Parts Item # Service Parts Wood Stove Series ACC Service And Maintenance Log Date of Service Performed By Description of Service Wood Stove Series ACC Homeowner’s Notes Wood Stove Series ACC Homeowner’s Notes Cont’d Lifetime Warranty Wood Stove Series ACC Warranty Policy Wood Stove Series ACC Contact Information