Quadra-Fire SAPPH-D-CWL Grille Cover Plate Installation, Accessories, 059 53 DMS 096 41DMS

Figure 8.9 Remove burner by sliding the shutter to the right, lifting up the left side of the burner and sliding it the the left.

Figure 8.10 Remove the main burner orifice using a 5/8 in. wrench.

Replace the orifice with the proper size as indicated for your gas type.

PROPANE	NATURAL GAS
.059 (53 DMS)	.096 (41(DMS)

NOTE: If the venting configuration has no vertical rise, a derating orifice must be installed. The derating orifices are supplied with the rear vent conversion kit.

Reinstall the burner. Slide the burner neck into the shutter and over the orifice. Refer to Figure 8.10.

Reinstall the burner pan locators on the left and right side of the burner. Secure with one screw to each side.

Install logs, referring to instructions on page 33.

Replace glass door and front.

C. Grille Cover Plate Installation

Top grill cover is shipped with the appliance and is an optional use item. It may be used with rear or top venting. Primarily its purpose is to hide the interior of the top of the appliance from being viewed through the top grill piece. Its use will also increase the efficiency of the blower, if a blower is installed on the appliance.

To prepare the part for use you will need tin snips, pliers and a hammer.

1, For use with top venting: See Figure 8.11, below. Use the tin snips to cut the straight edges.

2.Gently bend the piece until the two attached sections of the circular area snap apart. Discard this piece.

3.Bend the tabs up towards the black painted side.

4.With the top grill lying face down, set the black painted side of grill cover onto the grill.

5.Use the hammer to tap on the four speed nuts (also supplied with the appliance.)

6.For use with rear venting: Follow steps 3 through 5, leaving the cover piece intact.

SNIP HERE

BEND 7 TABS

TOWARDS

PAINTED SIDE

Figure 8.11

D. Accessories

Install approved accessories per instructions included with accessories. Refer to Section 12 for appropriate accesso- ries.

WARNING

Shock or fire risk.

Use ONLY optional accessories approved for this appliance.

•Using non-listed accessories voids warranty.

•Using non-listed accessories may result in a safety hazard.

•Only Hearth & Home Technologies approved accessories may be used safely.

January 28, 2008 Quadra-Fire · Sapphire · 250-7233E Page 31