Quadra-Fire 839-1460, SAPPH-D-CWL, 839-1390, SAPPH-D-CSB, 839-1440 Existing Masonry Chimney, Ft m

4. Existing Masonry Chimney

Type A - Up & Out Installations for Top Vent Configurations

	TERMINATION
TOP ADAPTOR	CAP
	FLASHING

RETRO
CONNECTOR	4 in. (102mm)
90 DEGREE	FLEX LINER
ELBOW

DIRECT VENT

PIPE

Type B - Hearth Rear Vent Installations for Use With Rear Vent Kit (see Section 12 for conversion kit and venting components.)

Chimney Liner

Termination Cap

Part #923GK

	Co-Axial to	3 in. (76mm)Flex
	Co-Linear	Liner
	Connector
	Part #923GCL
Pipe Length
Optional
		Showing two
		30 ft. (9m)
		Sections of Flex
		Liner

Chimney Liner

Termination Cap

Co-Axial to Co-Linear

Connector

Pipe Length

Optional

30 ft. (9m) of 3 in. (76mm) Flex Liner Exhaust Section

This section of the chimney MUST be sealed

The chimney must be sealed from the 4 ft. (1m) section to termination

using a smoke shelf or a damper*.

The seal should be 6 in. (152mm) below the end of the 4 ft. (1m) Air Intake section.

4 ft. (1m) of 3 in. (76mm)

Flex Liner

Air Intake Section

Figure 5.23

*In the Commonwealth of Massachusetts, the word damper shall be replaced with the words flue restrictor.

Page 20 Quadra-Fire · Sapphire · 250-7233F January 28, 2008