Quadra-Fire CASTILEI-CE-MBK Castile & Santa Fe CE Insert Door Handle Removal, Door Removal

R

Castile & Santa Fe CE Insert

C. Door Handle Removal

1.Open the outer door.

2.Unlatch and open the firebox door.

3.Continue to turn handle until it is free from the firebox door.

9.There are 3 holes in the back flange of the top to secure it to the wall if necessary. Use the appropriate fastener for the type of wall material, i.e., brick, sheetrock, etc.

NOTE: 9.5mm thick tile or like material can be cut to size and fit under lip of top trim edge for a decorative touch.

Figure 32.3.

D. Door Removal

1.Open the outer door.

2.Unlatch and open the firebox door.

3.Lift the firebox door up, freeing it from the firebox hinges.

E. Adjustable Hearth Support

Size: 229mm d x 1143mm w, 51mm to 254mm Height Adjustment

Included in Kit: (1) trim top, (1) trim front, (2) trim sides, double-sided tape (already installed)

Tools Needed: Phillips head screwdriver, sheet metal shears, measuring tape, gloves

1.The 10 screws on each set of scissors will already be loose when shipped. Figure 32.1.

2.Expand scissors to desired height. Tighten screws to hold in place using Phillips head screwdriver.

3.Measure front and side trims to required height to cover scissors and mark pieces for cutting. Cut excess material from top of trim’s edge, not bottom. This edge will be sharp; wear gloves to prevent injury to your hands. Figure 32.2.

4.Using sheet metal shears, cut trim along the marked edge. The cut edge fits under lip of top trim, so it allows for some variance in your straight edge.

5.The double-sided tape that holds front and side trims to scissors has a powerful bonding adhesive. Adjust- ments are extremely difficult once trim has adhered to tape. Do a dry run first without removing paper from tape.

6.Place cut edge of trim under top lip and into position on scissors. Place side pieces on first and then front piece. The front piece overlaps side pieces.

7.Once you are satisfied with the positioning, remove trim and set aside.

8.Remove the paper from double-sided tape that is to accept trim side. Align side and then press hard against tape to secure side piece. Repeat for other side. Install front trim piece last.

EXPLODED VIEW OF SCISSORS
	SCREWS ARE CIRCLED
DOUBLE-SIDED TAPE	DOUBLE-SIDED TAPE

Figure 32.1

EXPAND SCISSORS TO DESIRED HEIGHT

CUT TOP EDGE OF TRIM,

INSTALL FRONT TRIM LAST. NOT BOTTOM EDGE CORNERS OVERLAP SIDE

TRIM PIECES

Figure 32.2

Decorative tile

may be installed

Figure 32.3

WARNING

Sheet metal trim edges will be sharp.

For safety purposes wear gloves.

Injury can occur.

October 27, 2011 7069-101B Page 29