Quadra-Fire SANTAFEI-CE-MBK owner manual Castile & Santa Fe CE Insert Surround and Cast Trim Set

Castile & Santa Fe CE Insert

R

H. Surround and Cast Trim Set

(CASTILE INSERT)

Included in Surround Kit: (2) side surrounds, left and right; (1) surround top; (1) fastener package.

Included in Cast Trim Kit: (2) cast trim legs, left and right; (1) cast trim header; (2) cast trim footers, left and right

Tools Needed: Powered 102mm to 152mm Phillips head screwdriver

1. Remove contents from box being careful not to scratch or
	damage the cast trim pieces.
2.	Lay the surround set face down on protective covering to
	prevent scratching the painted surface.
3.	Using a 102mm to 152mm long Phillips head screwdriver to
	attach the side surrounds to the top surround using (2) #8
	sheet metal screws on each side provided with the kit.
4.	Place the peel and stick round felt vibration insulation pads on
	the front side in each corner of the top metal piece and on the
	back side in each corner of the top cast piece. Figure 32.1.
5.	Place the corresponding cast trim pieces (2 cast trim sides
	and 1 cast trim header) underneath the surround set, also face
	down. Align the holes in the metal pieces with the 5 bosses

(4) Felt Vibration Insulation Pads

Secure

Surrounds to

Cast Trim Kit

Attach Magnet

before installing

Cast Footers

Cast Footers,

Left & Right

Magnet Installed

Figure 32.1

	on the top cast piece and 2 bosses on each side piece.
6.	Secure the magnet to the bracket and attach the magnet and
	bracket to each metal side piece at the bottom. The magnet
	is facing the front. Figure 32.2.
7.	Place the cast footers under the metal sides aligning the top
	and bottom holes in the cast footers and metal sides.
8.	The 9 mounting clips are shipped in one long strip. Hand
	break apart or use pliers.
9.	Each clip has a clearance notch to allow room for the cast
	on the insert. Place the clip so the notch is facing the outer
	edges of the surrounds. Figure 32.3.
10. It is best to install all of the 1/4-20 screws only half way at
	first to allow for adjustments. After adjustment, tighten the 2
	screws in each cast footer first and then work your way around
	to the rest.

Back

of

Side

Piece

Magnet Attached - Faces Front

Figure 32.2

Clearance Notch

Figure 32.3

11 Remove the cast sides before attaching the surround
and trim. Lift up the top to expose the thumb screws at
the top of cast side. Figure 32.4.
12. Remove the thumb screw and top bracket and then
remove the cast side. Lay it down on a soft surface to			Thumb
avoid scratching the cast.			Screw
13 Slide surround and trim over the top of the insert into			Bracke
place. Surround attachs to insert at the top and bottom
of insert side. Figure 32.4.
14. Re-install the cast sides and secure with the thumb		Surround Set
screws.
		attaches to top
CAUTION		and bottom of
		insert sides.
Do not pick up assembled appliance by corners.		Figure 32.4
It is too heavy and may damage the surrounds.
Pick up from center.
Page 32	7069-101B		October 27, 2011