R
Castile & Santa Fe CE Insert
B. Thermostat Location
The thermostat’s location will have some effect on the appliance’s operation.
When the thermostat is located close to the appliance, it may require a slightly higher temperature setting to keep the rest of the house comfortable.
If the thermostat location is in an adjacent room or on a different floor level, you will notice higher temperatures near the appliance.
C. Tools And Supplies Needed
Tools and building supplies normally required for instal- lation.
E. Pre-Burn Check List
1. | Place the appliance in a location near the |
| final installation area and follow the proce- |
| dures below: |
2. | Open the appliance and remove all the parts |
| and articles packed inside the Component |
| Pack. Inspect all the parts and glass for ship- |
| ping damage. Contact your dealer if any irregu- |
| larities are noticed. |
3. | All safety warnings have been read and fol- |
| lowed. |
4. | This Owner’s Manual has been read. |
5. | Floor protection requirements have been met. |
6. | Venting is properly installed. |
Reciprocating Saw
Hammer
Phillips Screwdriver
Tape Measure
Plumb Line
Level
Framing Material
Gloves
Safety Glasses
7/16 inch Socket Wrench (or 10mm 6 pt or 11mm 6 pt socket)
Framing Square
Electric Drill & Bits
May also need: Vent Support Straps
7. | The proper clearances from the appliance and |
| chimney to combustible materials have been |
| met. |
8. | The masonry chimney is inspected by a profes- |
| sional and is clean, or the factory built metal |
| chimney is installed according to the manufac- |
| turer’s instructions and clearances. |
9. | The chimney meets the required minimum |
| height. |
10. | All labels have been removed from the glass |
| door. |
D. Inspect Appliance and Components
WARNING! Risk of Fire! Damaged parts could impair safe operation. Do NOT install damaged, incomplete or substitute components.
•Open the appliance and remove all the parts and articles packed inside the Component Pack. Inspect all the parts and glass for shipping damage.
•Report to your dealer any parts damaged in shipment.
•All labels have been removed from the glass door.
•Plated surfaces have been wiped clean with a soft cloth, if applicable.
•Read all the instructions before starting the installation.
Follow these instructions carefully during the installation to ensure maximum safety and benefit.
•Follow pipe manufacturer instructions for installation and air clearance requirments.
11. | Plated surfaces have been wiped clean, if |
| applicable. |
12. | Thermostat or remote has been installed. |
13. | A power outlet is available nearby. |
October 27, 2011 | Page 19 |
