R
Castile & Santa Fe CE Insert
D. General Operating Information
1. Thermostat Calls For Heat
The appliance is like most modern furnaces; when the thermostat calls for heat, your appliance will automatically light and deliver heat.
When the room is up to temperature and the thermostat is satisfied, the red call light will shut off and the appliance will shut down. The red call light is located behind the right access panel.
2. Heat Output Controls
This appliance is equipped with a heat output control switch that has three settings or burn rates; low, medium and high.
Figure 9.1.
The appliance will turn on and off as the thermostat demands. When the thermostat calls for heat, the appliance will always start up on High. After burning approximately 4 minutes, the appliance will then burn at the rate at which it was originally set. If the appliance is set at one of the lower settings, it will run quieter but takes longer to heat up an area than if it were set at a higher burn rate.
Regardless of the burn rate, when the area is warm enough to satisfy the thermostat, the appliance will shut off.
High |
Med |
Low |
Reset |
Button |
Figure 9.1
WARNING
Fire Hazard.
Keep combustible materials, gasoline and other flammable vapors and liquids clear of appliance.
•Do NOT store flammable materials in the appliance’s vicinity.
•DO NOT USE GASOLINE, LANTERN FUEL, KEROSENE, CHARCOAL LIGHTER FLUID OR SIMILAR LIQUIDS TO START OR “FRESHEN UP” A FIRE IN THIS HEATER.
•DO NOT BURN GARBAGE OR FLAMMABLE FLUIDS SUCH AS GASOLINE, NAPHTHA OR ENGINE OIL.
•DO NOT USE CHEMICALS OF FLUIDS TO START THE FIRE.
•Keep all such liquids well away from the heater while it is in use.
•Combustible materials may ignite.
E.Before Your First Fire
1.First, make sure your appliance has been properly installed and that all safety requirements have been met. Pay particular attention to the fire protection, venting and thermostat installation instructions.
2.Double check that the ash drawer and firebox are empty!
3.Close the front door.
CAUTION
Tip of thermocouple must be in contact with the inside end of the thermocouple cover.
Missed ignitions can occur.
F. Filling the Hopper with Fuel
a.Open the hopper lid and pull the lid towards you.
b.Do not over fill the hopper. The lid must be completely closed to maintain proper vacuum and for the feed motor to operate. An error message will appear on the wall control if the lid is not properly closed.
c.Remove any sawdust or fuel from the lid gasket after refilling hopper.
d.Do not leave any part of the fuel bag on the appliance after refilling hopper.
e.Store fuel away from the appliance to maintain proper safe air clearance to combustibles.
October 27, 2011 | Page 9 |
