Radio Shack 16-830 owner manual Playback

16-830.fm Page 34 Wednesday, July 21, 1999 9:32 AM

5.Using the supplied 75-ohm antenna cable, connect the RF converter’s OUT TO TV jack to the TV’s VHF antenna terminal.

•If the TV’s VHF antenna terminal is the round, 75-ohm type, connect the cable directly to the terminal.

•If the TV’s VHF antenna terminal is the flat, 300-ohm type, use another matching transformer (such as Cat. No. 15-1253, not supplied) to connect the cable to the terminal.

6.Set CHANNEL on the RF converter to 3 or 4.

CHANNEL

PLAYBACK

After you connect the camcorder to your TV, fol- low these steps to play a tape.

1.Turn on the TV, then:

•If you are using a TV with audio/video (A/V) jacks, set it to the video mode.

•If you are using a standard TV, set the TV’s tuner to the same channel where you set CHANNEL on the RF converter (3 or 4).

2.Slide POWER on the camcorder to VCR.

3.Insert a cassette into the camcorder.

4.Press PLAY on the camcorder. The tape plays on your TV.

5.Press STOP/EJECT to stop playback. Press STOP/EJECT again to remove the cassette.

34