Installation
! IMPORTANT !
Be sure the battery pack is properly connected before you try to charge it. The CHARGE/IN USE indicator lights when the handset is on the base even if the battery pack is not connected properly.
Ô NOTE Ô
•If the phone does not work, recharge the battery pack. (The battery power might be too low for the display to operate.)
•If the battery pack becomes weak during a call, the handset beeps and TALK/BATT LOW
LED flashes. When this happens, you cannot make a call on the phone until you recharge the battery pack.
•If the battery pack is completely discharged or the base loses power while the handset is away from it, place the handset on the base to change the security
3. Plug the battery pack’s connector into the socket in the compartment. The connector fits only one way.
4. Put the battery pack in the compartment.
5. Replace the cover.
To charge the battery pack, place the handset on the base, face up or down. The base’s CHARGE/IN USE indicator lights. !
Recharge the battery pack when TALK/BATT LOW LED flashes.Ô
When you first use the phone after charging or recharging the battery pack, the phone might not work and you might hear error beeps. If this happens, while holding find hs, place the handset to the base for about 5 seconds to change the security
Using a pencil eraser, clean the charging contacts on the handset and the base about once a month.
About once a month, fully discharge the battery pack by keeping the handset off the base until TALK/BATT LOW LED flashes. Otherwise, the battery pack loses its ability to fully recharge.
10
