Additional Information

Ô NOTES Ô

If you place the handset on the base to recharge it while the headset is connected, be sure the handset seats properly.

You can use a handset holder (available from your local RadioShack store) to hang the handset on your belt for greater convenience when using a headset.

ADDITIONAL

INFORMATION

INSTALLING THE OPTIONAL BELTCLIP

To attach the beltclip

Insert the beltclip into the holes on each side of the handset. Press down until it clicks.

To remove the beltclip

Pull both sides of the beltclip to release the tabs from the holes.

HEADSET INSTALLATION

You can connect an optional headset with a 3/32- inch (2.5-mm) plug. Contact RadioShack for a suitable headset.

To connect the headset, open the rubber cover on the side of the handset. Then insert the headset’s plug into the jack. Ô

When you finish using the headset, disconnect it from the handset and close the rubber cover to protect the jack.

40

Page 40
Image 40
Radio Shack 43-3857 Additional Information, Installing the Optional Beltclip, Headset Installation, To attach the beltclip