Radio Shack 66 owner manual Set, Proceeding appears

16-635.fm Page 17 Wednesday, July 21, 1999 9:03 AM

7.At this screen (depending on your setup), set your cable box to channel 02 or direct- to-home satellite receiver to channel 270. Then press .

UR CABLE

	R DSS
	270.
KEY	KEY
Cable Box	Direct-to-Home
	Satellite Receiver

NOW TRANSMITTING appears, and the VCR sends a test signal to your cable box or direct-to-home satellite receiver.

8.After sending the test signal, the VCR dis- plays either of the following.

OX
?	E I VER
YES
	0?
KEY	KEY
Cable Box	Direct-to-Home
	Satellite Receiver

Check your cable box or direct-to-home satellite receiver. If it is tuned to Channel 9 (cable box) or Channel 200 (direct-to-home satellite receiver), this means the VCR is successfully controlling your equipment. Press or to highlight YES then press . If you connected a direct-to-home sat- ellite receiver, proceed now to “Alternate Setup” on Page 18.

If your cable box or direct-to-home satellite receiver does not tune to the specified

channel, press or to highlight NO,

then press and start over at Step 6. Try entering a different code assigned to your brand and repositioning the VCR and/or the equipment.

If it still does not tune to the specified chan- nels, this means the VCR cannot be set to automatically turn on and tune your partic- ular equipment to the correct channel

when it begins a timer or VCR Plus+ recording you set — you will need to do that manually (see “Recording” on Page 38). Press MENU/ACTION and pro- ceed to “Alternate Setup” on Page 18.

Note: “Using the VCR’s Remote Control with Your TV and Cable Box or Satellite Receiver” on Page 22 shows you how to use the remote control to operate your cable box or direct-to-home satellite receiver.

9.At this screen, press or to select your local PBS channel. Then press .

UR LOCAL

CABLE BOX

KEY

10.At this screen, set your cable box to the local PBS station, then press CH s.

SET

A CABLE

A CABLE

YOUR

THEN. . .

UP KEY

After you press CH s, CLOCK AUTO SET

PROCEEDING appears.

It can take up to 10 minutes for the VCR to set the clock using the EDS signal. If the VCR finds a signal, it automatically sets its clock to the correct time and AUTO CLOCK SET COMPLETED appears.

If the VCR does not detect a signal within this time, AUTO CLOCK SET INCOM- PLETE appears. There is probably not an EDS signal available in your area. Press MENU/ACTION, then see “Manually Setting the Clock” on Page 19 to set the clock.

17