Raymarine Ray54 manual Transmitting, Using the Scan Modes

Chapter 4: General Operations 23

4.9 Transmitting

Press and hold the Push-to-Talk (PTT) key on the microphone to transmit on the selected channel, then release to receive. The TX indicator appears during transmission.

Note: International regulations and good communications practice dictate that you not interfere with other communications. Before transmitting, listen to make sure the channel is clear.

The radio is equipped with a timeout timer in the event of a stuck key. After PTT has been held continuously for 5 minutes, transmission is discontinued and the radio automatically returns to receive mode. An Error beep is emitted 10 seconds before the time out is triggered and TX flashes on the display until PTT is released.

The TX time out timer is reset once the PTT key is released.

Note: If the current channel is receive-only, an alert tone sounds when PTT is pressed, indicating such a transmission is not permitted.

4.10 Using the Scan Modes

The Ray54 is equipped with four types of scan options: All Scan, Saved (Memory) Scan, Priority All Scan and Priority Saved Scan. If there are no channels in memory, the default is All Scan.

This function automatically searches for broadcasting channels. If a transmission is received, the scan stops on the receiving channel as long as it is present. If the signal is lost for five seconds, the radio resumes scanning.

During the Scan Modes:

•Press the microphone Channel UP/DOWN keys or rotate the CH knob on the main unit to change the scan direction. UP (CH key)/clockwise (CH knob) increments the channel while DOWN (CH key) /counterclockwise (CH knob) decrements it.

•Press and release SCAN/SAVE to terminate the SCAN mode.

•Press and release CLEAR/WX to terminate the SCAN mode.

•Press 16/9 to terminate the SCAN mode and tune to the Priority Channel.

•DW/TRI and HILO/USER keys are disabled.