RCA 620, 608WL, 605 manual Mapping, Creating a NAT template, Group, Type

Chapter 5

Expert Configuration

Creating a NAT Proceed as follows to create a address translation mapping:

mapping 1	Click New to create a new map.
2	Select or fill in all the fields (see above).
3	Click Apply.

Templates The Template page allows you to create a NA(P)T template.

Depending on your needs following fields are available:

Interface:

The name of the IP interface that needs to be NAT-ed.

Group:

The IP interface group scope for this template.

Type:

Allows you to choose the translation type.

Protocol:

The IP protocol on which address translation has to be applied. This allows the SpeedTouch™ to link specific traffic (protocol dependent) to a chosen private host.

Outside address:

The outside (typically public) IP address(es).

Inside address:

The inside (typically private) IP address(es).

Access list:

You can use the access list to define the address(es) that are allowed to use the outbound connections.

Foreign address:

Foreign address is to define the address (es) that are allowed to use the inbound connections.

Flags

Description

Creating a NAT template

If you selected NAPT, you will have to specify a port range for the inside and outside address.

Proceed as follows to create a template:

1Click New to create a new template.

2Select or fill in all the fields (see above).

3Click Apply.

130 E-DOC-CTC-20051017-0151 v1.0