RCA 620, 608WL, 605 manual Resetting your SpeedTouch, Software reset Hardware reset

Chapter 7

Troubleshooting

7.3 Reset to Factory Defaults

Resetting your SpeedTouch™

You might consider a reset to factory defaults as described below.

!	Be aware that a reset to factory defaults will revoke all configurational
	changes you made to the SpeedTouch™.

You can choose between:

Software reset

Hardware reset

A reset to factory default settings deletes the configuration profile settings. Therefore, after the reset, a reconfiguration of your SpeedTouch™ will be needed.

Also your WLAN clients will have to be re-associated, as described in “2.2.2 Connecting Wireless Clients for the First Time” on page 20.

Software reset Proceed as follows:

1Go to the SpeedTouch™ Web pages.

2In the menu, select SpeedTouch > Configuration.

3In the Pick a task list, click Reset my SpeedTouch to default settings. The SpeedTouch™ restarts.

4The SpeedTouch™ returns to the SpeedTouch™ home page (unless the IP address of your computer is not in the same subnet as the default IP address of the SpeedTouch™, being 192.168.1.254).

Hardware reset Proceed as follows:

1Make sure the SpeedTouch™ is turned on.

2Use a pen or an unfolded paperclip to push the recessed reset button on the back panel. The reset button is marked with a red circle. Push it until the power LED lights red - this will take about 7 seconds.

ON

18VAC OFF

Reset Asso-

Consoleciation

1 2

ISDN

3 4

3Release the reset button.

194 E-DOC-CTC-20051017-0151 v1.0